Cisco 6500 Series Software Configuration Manual page 111
Hide thumbs
Also See for 6500 Series:
- Configuration manual (392 pages) ,
- Configuration note (212 pages) ,
- Installation manual (194 pages)
Table of Contents
Advertisement
Chapter 7
Configuring LAN Ports for Layer 2 Switching
To configure the default VLAN, perform this task:
Command
Router(config-if)# switchport access vlan vlan_ID
Router(config-if)# no switchport access vlan
Complete the steps in the
Note
tasks in this section.
Configuring the 802.1Q Native VLAN
Complete the steps in the
Note
page 7-8
To configure the 802.1Q native VLAN, perform this task:
Command
Router(config-if)# switchport trunk native vlan
vlan_ID
Router(config-if)# no switchport trunk native vlan
When configuring the native VLAN, note the following syntax information:
•
•
•
Complete the steps in the
Note
tasks in this section.
Configuring the List of VLANs Allowed on a Trunk
Note
Complete the steps in the
page 7-8
78-14099-04
"Completing Trunk Configuration" section on page 7-13
"Preparing a Layer 2 Switching Port for Configuration as a Trunk" section on
before performing the tasks in this section.
With Release 12.1(13)E and later releases, the vlan_ID value can be 1 to 4094, except for reserved
VLANs (see
Table 9-1 on page
With 12.1 E releases earlier than Release 12.1(13)E, the vlan_ID value can be 1 to 1005.
The access VLAN is not automatically used as the native VLAN.
"Completing Trunk Configuration" section on page 7-13
"Preparing a Layer 2 Switching Port for Configuration as a Trunk" section on
before performing the tasks in this section.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Configuring LAN Interfaces for Layer 2 Switching
Purpose
(Optional) Configures the default VLAN, which is used if the
interface stops trunking.
With Release 12.1(13)E and later releases, the vlan_ID
•
value can be 1 to 4094, except for reserved VLANs (see
Table 9-1 on page
With 12.1 E releases earlier than Release 12.1(13)E, the
•
vlan_ID value can be 1 to 1005.
Reverts to the default value (VLAN 1).
Purpose
(Optional) Configures the 802.1Q native VLAN.
Reverts to the default value (VLAN 1).
9-2).
9-2).
after performing the
after performing the
7-11
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco 6500 Series
Related Products for Cisco 6500 Series
- Cisco 6503 - Catalyst Firewall Security Sys
- Cisco 6503-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6504-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6506 - Catalyst Chassis Switch
- Cisco 6513 - Catalyst Switch
- Cisco Catalyst 6509
- Cisco Catalyst 6513-E
- Cisco Catalyst 6500-E Series