Cisco 6500 Series Software Configuration Manual page 43
Hide thumbs
Also See for 6500 Series:
- Configuration manual (392 pages) ,
- Configuration note (212 pages) ,
- Installation manual (194 pages)
Table of Contents
Advertisement
Chapter 3
Configuring the Switch for the First Time
Note
Enter the virtual terminal password when the following is displayed (remember this password for future
Step 6
reference):
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: bambam
In most cases you will use IP routing. If so, you must also select an interior routing protocol, for
Step 7
example, the Enhanced Interior Gateway Routing Protocol (EIGRP).
Enter yes (the default) or press Return to configure IP, and then select EIGRP:
Configure IP? [yes]:
Configure EIGRP routing? [yes]:
Your IGRP autonomous system number [1]: 301
Enter yes or no to accept or refuse SNMP management:
Step 8
Configure SNMP Network Management? [yes]:
Community string [public]:
For complete SNMP information and procedures, refer to these publications:
Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.1, "Cisco IOS System
•
Management," "Configuring SNMP Support," at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/fun_c/fcprt3/fcd301.htm
Cisco IOS Configuration Fundamentals Configuration Command Reference, Release 12.1, at
•
this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/fun_r/index.htm
To provide a review of what you have done, a display similar to the following appears and lists all of the
configuration parameters you selected in Steps
shown in the order in which they appeared on your console terminal:
The following configuration command script was created:
hostname router
enable secret 5 $1$S3Lx$uiTYg2UrFK1U0dgWdjvxw.
enable password lab
line vty 0 4
password lab
no snmp-server
!
ip routing eigrp 301
!
interface Vlan1
shutdown
no ip address
!
interface GigabitEthernet1/1
78-14099-04
An enable secret password can contain from 1 to 25 uppercase and lowercase alphanumeric
characters; an enable password can contain any number of uppercase and lowercase
alphanumeric characters. In both cases, a number cannot be the first character. Spaces are also
valid password characters; for example, "two words" is a valid password. Leading spaces are
ignored; trailing spaces are recognized.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
3
through 8. These parameters and their defaults are
Configuring the Switch
3-7
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco 6500 Series
Related Products for Cisco 6500 Series
- Cisco 6503 - Catalyst Firewall Security Sys
- Cisco 6503-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6504-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6506 - Catalyst Chassis Switch
- Cisco 6513 - Catalyst Switch
- Cisco Catalyst 6509
- Cisco Catalyst 6513-E
- Cisco Catalyst 6500-E Series