Dot1X Timeout Tx-Period - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

Command Mode

Interface (Ethernet) Configuration mode

User Guidelines

The default value of this command should be changed only to adjust to unusual

circumstances, such as unreliable links or specific behavioral problems with

certain clients and authentication servers.

The command is only applied to the 802.1x authentication method.

The following example sets the time interval during which the device waits for a

response to an EAP request frame from the client before resending the request to

3600 seconds.

switchxxxxxx(config)#

switchxxxxxx(config-if)#

2.25 dot1x timeout tx-period

Use the dot1x timeout tx-period Interface Configuration mode command to set the

time interval during which the device waits for a response to an Extensible

Authentication Protocol (EAP) request/identity frame from the client before

resending the request. Use the no form of this command to restore the default

configuration.

dot1x timeout tx-period

no dot1x timeout tx-period

—Specifies the time interval in seconds during which the device

waits for a response to an EAP-request/identity frame from the client before

resending the request. (Range: 30–65535 seconds).

Default Configuration

The default timeout period is 30 seconds.

interface gi11

dot1x timeout supp-timeout

OL-32830-01 Command Line Interface Reference Guide

802. 1 X Commands