Cisco 1941W Configuration Manual page 119
Cisco 3900 series, cisco 2900 series,
cisco 1900 series
Hide thumbs
Also See for 1941W:
- Hardware installation manual (102 pages) ,
- Installing and upgrading (24 pages)
Table of Contents
Advertisement
Chapter
Configuring Backup Data Lines and Remote Management
Command
Step 3
exit
Example:
Router(config-dhcp)# exit
Router(config)#
Step 4
chat-script script-name expect-send
Example:
Router(config)# chat-script Dialout ABORT ERROR
ABORT BUSY "" "AT" OK "ATDT 5555102 T" TIMEOUT 45
CONNECT \c
Router(config)#
Step 5
interface type number
Example:
Router(config)# interface Async 1
Router(config-if)#
Step 6
exit
Example:
Router(config-if)# exit
Router(config)#
Step 7
interface type number
Example:
Router(config)# interface Dialer 3
Router(config-if)#
Step 8
dialer watch-group group-number
Example:
Router(config-if)# dialer watch-group 1
Router(config-if)#
Step 9
exit
Example:
Router(config-if)# exit
Router(config)#
Step 10
ip nat inside source {list access-list-number} {interface
type number | pool name} [overload]
Example:
Router(config)# ip nat inside source list 101
interface Dialer 3 overload
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Configuring Dial Backup and Remote Management Through the Console Port or Auxiliary Port
Purpose
Exits DHCP pool configuration mode and
enters global configuration mode.
Configures a chat script for use in DDR to
give commands for dialing a modem and
for logging in to remote systems. The
defined script is used to place a call over a
modem connected to the PSTN.
Creates asynchronous interface and enters
configuration mode for the asynchronous
interface.
Configure the asynchronous interface. For
sample commands that you can use in
asynchronous interface configuration
mode, see the
"Example" section on
page
113.
Exits interface configuration mode and
enters global configuration mode.
Creates dialer interface and enters
configuration mode for the dialer
interface.
Specifies the group number for the dialer
watch list.
Exits interface configuration mode and
enters global configuration mode.
Enables dynamic translation of addresses
on the inside interface.
111
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
