Configuration Example For Ethernet Cfm (Port Mep); Verifying The Ethernet Cfm Configuration On A Port Mep - Cisco 1941W Configuration Manual
Cisco 3900 series, cisco 2900 series,
cisco 1900 series
Hide thumbs
Also See for 1941W:
- Hardware installation manual (102 pages) ,
- Installing and upgrading (24 pages)
Table of Contents
Advertisement
CFM Support on Routed Port and Port MEP
Command
Step 10
interface gigabitethernet slot/port
Example:
Router(config)#interface
gigabitethernet 0/2
Step 11
ethernet cfm mep domain domain-name
mpid mpid-value service service-name
Example:
Router(config-if)#ethernet cfm mep
domain carrier mpid 44 service
carrier
Step 12
end
Example:
Router(config-if-ecfm-mep)#end
Configuration Example for Ethernet CFM (Port MEP)
This example shows how to configure Ethernet CFM on a port MEP:
Router>enable
Router#configure terminal
Router(config)#ethernet cfm ieee
Router(config)#ethernet cfm global
Router(config-ecfm)#ethernet cfm domain carrier level 2
Router(config-ecfm)#service carrier port
Router(config-ecfm-srv)#continuity-check interval 100m
Router(config-ecfm-srv)#end
Router#configure terminal
Router(config)#interface gigabitethernet 0/2
Router(config-if)#ethernet cfm mep domain carrier mpid 44 service carrier
Router(config-if-ecfm-mep)#end
Verifying the Ethernet CFM Configuration on a Port MEP
Use the following commands to verify Ethernet CFM configured on a port MEP:
•
•
•
•
•
•
Use the show ethernet cfm domain command to view details about CFM maintenance domains:
Router#show ethernet cfm domain carrier
Domain Name: carrier
Level: 2
Total Services: 1
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
40
Chapter
show ethernet cfm domain
show ethernet cfm maintenance-points local
show ethernet cfm maintenance-points remote
ping ethernet mpid mpid-value domain domain-name service service-name cos value
traceroute ethernet mpid mpid-value domain domain-name service service-name
show ethernet cfm error configuration
Configuring Ethernet CFM and Y.1731 Performance Monitoring on Layer 3 Interfaces
Purpose
Specifies an interface and enters the interface
configuration mode.
Sets a port to a maintenance domain and defines it as an
MEP.
The values for domain and service must be the
Note
same as the values configured for CFM.
Returns the router to the privileged EXEC mode.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
