Cisco 1941W Configuration Manual page 4
Cisco 3900 series, cisco 2900 series,
cisco 1900 series
Hide thumbs
Also See for 1941W:
- Hardware installation manual (102 pages) ,
- Installing and upgrading (24 pages)
Table of Contents
Advertisement
Organization
Part 1
Module 1
Module 2
Module 3
Module 4
Module 5
Module 6
Module 7
Module 8
Module 9
Part 2
Module 1
Module 2
Module 3
Module 4
Part 3
Appendix A
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
2iv
Configuring the Router
Overview of Hardware and Software Describes new hardware and software features
Basic Router Configuration
Configuring Backup Data Lines and
Remote Management
Configuring Power Efficiency
Management
Configuring Security Features
Unified Communications on Cisco
Integrated Services Routers
Configuring Next-Generation
High-Density PVDM3 Modules
Multi-Gigabit Fabric
Communication
Upgrading the Cisco IOS Software
Configuring the Access Point
Wireless Overview
Configuring the Wireless Device
Configuring the Radio Settings
Administering the Wireless Device
Appendix
Cisco IOS CLI for Initial
Configuration
Description
in this release, features by platform, new slots,
common ports, and getting started tasks.
Describes how to perform the basic router
configuration, interface configuration, and
routing configuration.
Describes how to configure backup interfaces,
dial backup, and remote management.
Describes the hardware and software power
efficiency management features on the router.
See Cisco EnergyWise Configuration Guide for
information about configuring power efficiency
management on modules and interface.
Describes how to configure security features.
Describes voice application services that are
supported on these routers.
Describes how to configure the new
1
next-generation PVDM3
router.
Describes how modules and interface cards
inter-communicate using the MGF
router.
Describes how to upgrade the Cisco IOS
software image on the router or the access
point.
Description
Describes the autonomous image and recovery
image shipped on the Cisco 1941W access point
flash. Explains the default autonomous mode
and Cisco Unified mode.
Describes how to configure the autonomous
wireless device, how to upgrade the
autonomous software to Cisco Unified
software, and how to configure a Unified
wireless device.
Describes how to configure the radio settings
for the wireless device.
Describes many administration tasks for the
wireless device.
Description
Describes how to perform the initial
configuration of the router using the Cisco IOS
CLI, and additional configuration procedures
for the router.
Preface
installed on your
2
on the
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
