Cisp Enable - Cisco catalyst 3750 Command Reference Manual
Hide thumbs
Also See for catalyst 3750:
- Software configuration manual (926 pages) ,
- Command reference manual (854 pages) ,
- Hardware installation manual (231 pages)
Table of Contents
Advertisement
cisp enable
cisp enable
Use the cisp enable global configuration command to enable Client Information Signalling Protocol
(CISP) on a switch so that it acts as an authenticator to a supplicant switch.
Syntax Description
cisp enable
Defaults
There is no default setting.
Command Modes
Global configuration
Command History
Release
12.2(50)SE
Usage Guidelines
The link between the authenticator and supplicant switch is a trunk. When you enable VTP on both
switches, the VTP domain name must be the same, and the VTP mode must be server.
When you configure VTP mode, to avoid the MD5 checksum mismatch error, verify that:
•
•
Examples
This example shows how to enable CISP:
switch(config)# cisp enable
Related Commands
Command
dot1x credentials (global
configuration)
show cisp
Catalyst 3750 Switch Command Reference
2-66
cisp enable
no cisp enable
Enable CISP.
Modification
This command was introduced.
VLANs are not configured on two different.switches, which can be caused by two VTP servers in
the same domain.
Both switches have the different configuration revision numbers.
profile
Description
Configures a profile on a supplicant switch.
Displays CISP information for a specified interface.
Chapter 2
Catalyst 3750 Switch Cisco IOS Commands
OL-8552-07
- Quick Links:
- Cli Command Modes
Hide quick links:
Advertisement
Chapters
Table of Contents
