Ip Igmp Filter - Cisco catalyst 3750 Command Reference Manual

Hide thumbs Also See for catalyst 3750:

Table of Contents

ip igmp filter

Use the ip igmp filter interface configuration command to control whether or not all hosts on a Layer 2

interface can join one or more IP multicast groups by applying an Internet Group Management Protocol

(IGMP) profile to the interface. Use the no form of this command to remove the specified profile from

the interface.

Syntax Description

profile number

No IGMP filters are applied.

Command Modes

Interface configuration

Command History

Usage Guidelines

You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed

ports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.

An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one

profile applied to it.

This example shows how to apply IGMP profile 22 to a port:

Switch(config)# interface gigabitethernet1/0/2

Switch(config-if)# ip igmp filter 22

You can verify your setting by using the show running-config privileged EXEC command and by

specifying an interface.

Catalyst 3750 Switch Command Reference

ip igmp filter profile number

no ip igmp filter

The IGMP profile number to be applied. The range is 1 to 4294967295.

Modification

This command was introduced.

Catalyst 3750 Switch Cisco IOS Commands

Show Quick Links

Table of Contents