Cisco IE 3000 Software Configuration Manual page 271
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Chapter 12
Configuring Smartports Macros
Command
Step 7
macro {apply | trace} macro-name
[parameter {value}] [parameter
{value}] [parameter {value}]
Step 8
end
Step 9
show running-config interface
interface-id
Step 10
copy running-config startup-config
You can delete a global macro-applied configuration on a switch only by entering the no version of each
command that is in the macro. You can delete a macro-applied configuration on an interface by entering
the default interface interface-id interface configuration command.
This example shows how to display the cisco-desktop macro, how to apply the macro, and to set the
access VLAN ID to 25 on an interface:
Switch# show parser macro cisco-desktop
--------------------------------------------------------------
Macro name : cisco-desktop
Macro type : default
# Basic interface - Enable data VLAN only
# Recommended value for access vlan (AVID) should not be 1
switchport access vlan $AVID
switchport mode access
# Enable port security limiting port to a single
# MAC address -- that of desktop
switchport port-security
switchport port-security maximum 1
# Ensure port-security age is greater than one minute
# and use inactivity timer
switchport port-security violation restrict
switchport port-security aging time 2
switchport port-security aging type inactivity
# Configure port as an edge network port
spanning-tree portfast
spanning-tree bpduguard enable
--------------------------------------------------------------
Switch#
Switch# configure terminal
Switch(config)# gigabitethernet1/4
Switch(config-if)# macro apply cisco-desktop $AVID 25
This example shows how to display the cisco-ethernetip macro and how to apply it to an interface:
Switch# show parser macro name cisco-ethernetip
Macro name :
Macro type : default interface
#macro name cisco-ethernetip
#macro keywords $access_vlan
OL-13018-01
Purpose
Append the Cisco-default macro with the required values by using the
parameter value keywords, and apply the macro to the interface.
Keywords that begin with $ mean that a unique parameter value is
required.
You can use the macro apply macro-name ? command to display a list
of any required values in the macro. If you apply a macro without
entering the keyword values, the commands are invalid and are not
applied.
Return to privileged EXEC mode.
Verify that the macro is applied to an interface.
(Optional) Save your entries in the configuration file.
cisco-ie-global
Configuring Smartports Macros
Cisco IE 3000 Switch Software Configuration Guide
12-7
Advertisement
Chapters
Table of Contents
Troubleshooting
