Cisco IE 3000 Software Configuration Manual page 697
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Appendix B
Working with the Cisco IOS File System, Configuration Files, and Software Images
Downloading a Configuration File By Using RCP
Beginning in privileged EXEC mode, follow these steps to download a configuration file by using RCP:
Command
Step 1
Step 2
Step 3
configure terminal
Step 4
ip rcmd remote-username username
Step 5
end
Step 6
copy
rcp:[[[//[username@]location]/directory]/filename]
system:running-config
or
copy
rcp:[[[//[username@]location]/directory]/filename]
nvram:startup-config
This example shows how to copy a configuration file named host1-confg from the netadmin1 directory
on the remote server with an IP address of 172.16.101.101 and load and run those commands on the
switch:
Switch# copy rcp://netadmin1@172.16.101.101/host1-confg system:running-config
Configure using host1-confg from 172.16.101.101? [confirm]
Connected to 172.16.101.101
Loading 1112 byte file host1-confg:![OK]
Switch#
%SYS-5-CONFIG: Configured from host1-config by rcp from 172.16.101.101
This example shows how to specify a remote username of netadmin1. Then it copies the configuration
file host2-confg from the netadmin1 directory on the remote server with an IP address of 172.16.101.101
to the startup configuration:
Switch# configure terminal
Switch(config)# ip rcmd remote-username netadmin1
Switch(config)# end
Switch# copy rcp: nvram:startup-config
Address of remote host [255.255.255.255]? 172.16.101.101
Name of configuration file[rtr2-confg]? host2-confg
Configure using host2-confg from 172.16.101.101?[confirm]
Connected to 172.16.101.101
Loading 1112 byte file host2-confg:![OK]
[OK]
Switch#
%SYS-5-CONFIG_NV:Non-volatile store configured from host2-config by rcp from
172.16.101.101
OL-13018-01
Purpose
Verify that the RCP server is properly configured by
referring to the
"Preparing to Download or Upload a
Configuration File By Using RCP" section on page
Log into the switch through the console port or a Telnet
session.
Enter global configuration mode.
This step is required only if you override the default remote
username (see Steps 4 and 5).
(Optional) Specify the remote username.
Return to privileged EXEC mode.
Using RCP, copy the configuration file from a network
server to the running configuration or to the startup
configuration file.
Cisco IE 3000 Switch Software Configuration Guide
Working with Configuration Files
B-16.
B-17
Advertisement
Chapters
Table of Contents
Troubleshooting
