Configuring Etherchannel Load Balancing - Cisco IE 3000 Software Configuration Manual
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Configuring EtherChannels
This example shows how to configure an EtherChannel. It assigns two ports as static-access ports in
VLAN 10 to channel 5 with the PAgP mode desirable:
Switch# configure terminal
Switch(config)# interface range gigabitethernet1/1 -2
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode desirable non-silent
Switch(config-if-range)# end
This example shows how to configure an EtherChannel. It assigns two ports as static-access ports in
VLAN 10 to channel 5 with the LACP mode active:
Switch# configure terminal
Switch(config)# interface range gigabitethernet1/1 -2
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode active
Switch(config-if-range)# end
Configuring EtherChannel Load Balancing
This section describes how to configure EtherChannel load balancing by using source-based or
destination-based forwarding methods. For more information, see the
Methods" section on page
Beginning in privileged EXEC mode, follow these steps to configure EtherChannel load balancing. This
procedure is optional.
Command
Step 1
configure terminal
Step 2
port-channel load-balance {dst-ip | dst-mac |
src-dst-ip | src-dst-mac | src-ip | src-mac}
Step 3
end
Step 4
show etherchannel load-balance
Step 5
copy running-config startup-config
Cisco IE 3000 Switch Software Configuration Guide
33-12
Chapter 33
33-6.
Purpose
Enter global configuration mode.
Configure an EtherChannel load-balancing method.
The default is src-mac.
Select one of these load-distribution methods:
dst-ip—Load distribution is based on the destination-host IP
•
address.
dst-mac—Load distribution is based on the destination-host
•
MAC address of the incoming packet.
src-dst-ip—Load distribution is based on the
•
source-and-destination host-IP address.
src-dst-mac—Load distribution is based on the
•
source-and-destination host-MAC address.
src-ip—Load distribution is based on the source-host IP
•
address.
•
src-mac—Load distribution is based on the source-MAC
address of the incoming packet.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring EtherChannels and Link-State Tracking
"Load Balancing and Forwarding
OL-13018-01
Advertisement
Chapters
Table of Contents
Troubleshooting
