Cisco IE 3000 Software Configuration Manual page 565

Hide thumbs Also See for IE 3000:

Table of Contents

Configuring Cisco IOS IP SLAs Operations

on the type of IP SLAs operation, it responds with time-stamp information for the source to make the

calculation on performance metrics. An IP SLAs operation performs a network measurement from the

source device to a destination in the network using a specific protocol such as UDP.

IP SLA measurement

and IP SLA responder to

IP SLA Responder

IP SLA responder

To implement IP SLAs network performance measurement, you need to perform these tasks:

For more information about IP SLAs operations, see the operation-specific chapters in the Cisco IOS IP

SLAs Configuration Guide at this URL:

http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_book09186a0080707055

The switch does not support Voice over IP (VoIP) service levels using the gatekeeper registration delay

operations measurements. Before configuring any IP SLAs application, you can use the show ip sla

application privileged EXEC command to verify that the operation type is supported on your software

Cisco IOS IP SLAs Operation

Any IP device

IP SLA measurement

and IP SLA responder to

IP SLA Responder

Enable the IP SLAs responder, if required.

Configure the required IP SLAs operation type.

Configure any options available for the specified operation type.

Configure threshold conditions, if required.

Schedule the operation to run, then let the operation run for a period of time to gather statistics.

Display and interpret the results of the operation using the Cisco IOS CLI or a network

management system (NMS) system with SNMP.

Cisco IE 3000 Switch Software Configuration Guide

Understanding Cisco IOS IP SLAs

IP SLA source

Chapters

Table of Contents