Understanding Ie 3000 Switch Alarms - Cisco IE 3000 Software Configuration Manual

Hide thumbs Also See for IE 3000:

Table of Contents

Configuring Cisco IE 3000 Switch Alarms

This section describes how to configure the different alarms for the Cisco IE 3000 switch.

This chapter consists of these sections:

For complete syntax and usage information for the commands used in this chapter, see the switch

command reference for this release.

Understanding IE 3000 Switch Alarms

The IE 3000 switch software monitors switch conditions on a per port or a switch basis. If the conditions

present on the switch or a port do not match the set parameters, the switch software triggers an alarm or

a system message. By default, the switch software sends the system messages to a system message

logging facility, or a syslog facility. You can also configure the switch to send Simple Network

Management Protocol (SNMP) traps to an SNMP server. You can configure the switch to trigger an

external alarm device by using the two independent alarm relays (major or minor). For more information

on how to configure the alarms, see the

This section includes information about these topics:

Understanding IE 3000 Switch Alarms, page 3-1

Configuring IE 3000 Switch Alarms, page 3-4

Displaying IE 3000 Switch Alarms Status, page 3-12

Global Status Monitoring Alarms, page 3-2

FCS Error Hysteresis Threshold, page 3-2

Port Status Monitoring Alarms, page 3-2

Triggering Alarm Options, page 3-3

C H A P T E R

"Configuring IE 3000 Switch Alarms" section on page

Cisco IE 3000 Switch Software Configuration Guide

Table of Contents