Disabling And Enabling Cdp - Cisco IE 3000 Software Configuration Manual
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Chapter 24
Configuring CDP
Command
Step 6
show cdp
Step 7
copy running-config startup-config
Use the no form of the CDP commands to return to the default settings.
This example shows how to configure CDP characteristics.
Switch# configure terminal
Switch(config)# cdp timer 50
Switch(config)# cdp holdtime 120
Switch(config)# cdp advertise-v2
Switch(config)# end
For additional CDP show commands, see the
Disabling and Enabling CDP
CDP is enabled by default.
Switch clusters and other Cisco devices (such as Cisco IP Phones) regularly exchange CDP messages.
Note
Disabling CDP can interrupt cluster discovery and device connectivity. For more information, see
Chapter 6, "Clustering Switches"
Cisco.com.
Beginning in privileged EXEC mode, follow these steps to disable the CDP device discovery capability:
Command
Step 1
configure terminal
Step 2
no cdp run
Step 3
end
Beginning in privileged EXEC mode, follow these steps to enable CDP when it has been disabled:
Command
Step 1
configure terminal
Step 2
cdp run
Step 3
end
This example shows how to enable CDP if it has been disabled.
Switch# configure terminal
Switch(config)# cdp run
Switch(config)# end
OL-13018-01
Purpose
Verify your settings.
(Optional) Save your entries in the configuration file.
"Monitoring and Maintaining CDP" section on page
and see Getting Started with Cisco Network Assistant, available on
Purpose
Enter global configuration mode.
Disable CDP.
Return to privileged EXEC mode.
Purpose
Enter global configuration mode.
Enable CDP after disabling it.
Return to privileged EXEC mode.
Cisco IE 3000 Switch Software Configuration Guide
Configuring CDP
24-4.
24-3
Advertisement
Chapters
Table of Contents
Troubleshooting
