Ieee 802.1X Authentication Configuration Guidelines; Ieee 802.1X Authentication; Table - Cisco IE 3000 Software Configuration Manual
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Configuring IEEE 802.1x Authentication
Table 10-2
Default IEEE 802.1x Authentication Configuration (continued)
Feature
Quiet period
Retransmission time
Maximum retransmission number
Client timeout period
Authentication server timeout period
Guest VLAN
Inaccessible authentication bypass
Restricted VLAN
Authenticator (switch) mode
MAC authentication bypass
IEEE 802.1x Authentication Configuration Guidelines
These section has configuration guidelines for these features:
•
•
•
•
IEEE 802.1x Authentication
These are the IEEE 802.1x authentication configuration guidelines:
•
•
•
Cisco IE 3000 Switch Software Configuration Guide
10-20
Default Setting
60 seconds (number of seconds that the switch remains in the quiet state
following a failed authentication exchange with the client).
30 seconds (number of seconds that the switch should wait for a response to an
EAP request/identity frame from the client before resending the request).
2 times (number of times that the switch will send an EAP-request/identity
frame before restarting the authentication process).
30 seconds (when relaying a request from the authentication server to the
client, the amount of time the switch waits for a response before resending the
request to the client.)
30 seconds (when relaying a response from the client to the authentication
server, the amount of time the switch waits for a reply before resending the
response to the server.)
You can change this timeout period by using the dot1x timeout
server-timeout interface configuration command.
None specified.
Disabled.
None specified.
None specified.
Disabled.
IEEE 802.1x Authentication, page 10-20
VLAN Assignment, Guest VLAN, Restricted VLAN, and Inaccessible Authentication Bypass,
page 10-21
MAC Authentication Bypass, page 10-22
When IEEE 802.1x authentication is enabled, ports are authenticated before any other Layer 2
feature is enabled.
If you try to change the mode of an IEEE 802.1x-enabled port (for example, from access to trunk),
an error message appears, and the port mode is not changed.
If the VLAN to which an IEEE 802.1x-enabled port is assigned changes, this change is transparent
and does not affect the switch. For example, this change occurs if a port is assigned to a RADIUS
server-assigned VLAN and is then assigned to a different VLAN after re-authentication.
Chapter 10
Configuring IEEE 802.1x Port-Based Authentication
OL-13018-01
Advertisement
Chapters
Table of Contents
Troubleshooting
