Cisco IE 3000 Software Configuration Manual page 517
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Chapter 28
Configuring System Message Logging
Command
Step 4
logging trap level
Step 5
end
Step 6
show running-config
or
show logging
Step 7
copy running-config startup-config
Note
Specifying a level causes messages at that level and numerically lower levels to appear at the destination.
To disable logging to the console, use the no logging console global configuration command. To disable
logging to a terminal other than the console, use the no logging monitor global configuration command.
To disable logging to syslog servers, use the no logging trap global configuration command.
Table 28-3
the most severe level to the least severe level.
Table 28-3
Level Keyword
emergencies
alerts
critical
errors
warnings
notifications
informational
debugging
The software generates four other categories of messages:
•
•
•
OL-13018-01
Purpose
Limit messages logged to the syslog servers.
By default, syslog servers receive informational messages and
numerically lower levels (see
For complete syslog server configuration steps, see the
UNIX Syslog Servers" section on page
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
describes the level keywords. It also lists the corresponding UNIX syslog definitions from
Message Logging Level Keywords
Level
0
1
2
3
4
5
6
7
Error messages about software or hardware malfunctions, displayed at levels warnings through
emergencies. These types of messages mean that the functionality of the switch is affected. For
information on how to recover from these malfunctions, see the system message guide for this
release.
Output from the debug commands, displayed at the debugging level. Debug commands are
typically used only by the Technical Assistance Center.
Interface up or down transitions and system restart messages, displayed at the notifications level.
This message is only for information; switch functionality is not affected.
Table 28-3 on page
Description
System unstable
Immediate action needed
Critical conditions
Error conditions
Warning conditions
Normal but significant condition
Informational messages only
Debugging messages
Cisco IE 3000 Switch Software Configuration Guide
Configuring System Message Logging
28-9).
"Configuring
28-12.
Syslog Definition
LOG_EMERG
LOG_ALERT
LOG_CRIT
LOG_ERR
LOG_WARNING
LOG_NOTICE
LOG_INFO
LOG_DEBUG
28-9
Advertisement
Chapters
Table of Contents
Troubleshooting
