Spanning-Tree Interoperability And Backward Compatibility; Stp And Ieee 802.1Q Trunks; Configuring Spanning-Tree Features - Cisco IE 3000 Software Configuration Manual
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Configuring Spanning-Tree Features
Spanning-Tree Interoperability and Backward Compatibility
Table 16-2
network.
Table 16-2
PVST+
MSTP
Rapid PVST+
In a mixed MSTP and PVST+ network, the common spanning-tree (CST) root must be inside the MST
backbone, and a PVST+ switch cannot connect to multiple MST regions.
When a network contains switches running rapid PVST+ and switches running PVST+, we recommend
that the rapid-PVST+ switches and PVST+ switches be configured for different spanning-tree instances.
In the rapid-PVST+ spanning-tree instances, the root switch must be a rapid-PVST+ switch. In the
PVST+ instances, the root switch must be a PVST+ switch. The PVST+ switches should be at the edge
of the network.
STP and IEEE 802.1Q Trunks
The IEEE 802.1Q standard for VLAN trunks imposes some limitations on the spanning-tree strategy for
a network. The standard requires only one spanning-tree instance for all VLANs allowed on the trunks.
However, in a network of Cisco switches connected through IEEE 802.1Q trunks, the switches maintain
one spanning-tree instance for each VLAN allowed on the trunks.
When you connect a Cisco switch to a non-Cisco device through an IEEE 802.1Q trunk, the Cisco switch
uses PVST+ to provide spanning-tree interoperability. If rapid PVST+ is enabled, the switch uses it
instead of PVST+. The switch combines the spanning-tree instance of the IEEE 802.1Q VLAN of the
trunk with the spanning-tree instance of the non-Cisco IEEE 802.1Q switch.
However, all PVST+ or rapid-PVST+ information is maintained by Cisco switches separated by a cloud
of non-Cisco IEEE 802.1Q switches. The non-Cisco IEEE 802.1Q cloud separating the Cisco switches
is treated as a single trunk link between the switches.
PVST+ is automatically enabled on IEEE 802.1Q trunks, and no user configuration is required. The
external spanning-tree behavior on access ports and Inter-Switch Link (ISL) trunk ports is not affected
by PVST+.
For more information on IEEE 802.1Q trunks, see
Configuring Spanning-Tree Features
These sections contain this configuration information:
•
•
•
Cisco IE 3000 Switch Software Configuration Guide
16-10
lists the interoperability and compatibility among the supported spanning-tree modes in a
PVST+, MSTP , and Rapid-PVST+ Interoperability
PVST+
Yes
Yes (with restrictions)
Yes (reverts to PVST+)
Default Spanning-Tree Configuration, page 16-11
Spanning-Tree Configuration Guidelines, page 16-12
Changing the Spanning-Tree Mode., page 16-13
MSTP
Yes (with restrictions)
Yes
Yes (reverts to PVST+)
Chapter 13, "Configuring VLANs."
(required)
Chapter 16
Configuring STP
Rapid PVST+
Yes (reverts to PVST+)
Yes (reverts to PVST+)
Yes
OL-13018-01
Advertisement
Chapters
Table of Contents
Troubleshooting
