Cisco IE 3000 Software Configuration Manual page 362
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Configuring MSTP Features
Command
Step 3
instance instance-id vlan vlan-range
Step 4
name name
Step 5
revision version
Step 6
show pending
Step 7
exit
Step 8
spanning-tree mode mst
Step 9
end
Step 10
show running-config
Step 11
copy running-config startup-config
To return to the default MST region configuration, use the no spanning-tree mst configuration global
configuration command. To return to the default VLAN-to-instance map, use the no instance instance-id
[vlan vlan-range] MST configuration command. To return to the default name, use the no name MST
configuration command. To return to the default revision number, use the no revision MST configuration
command. To re-enable PVST+, use the no spanning-tree mode or the spanning-tree mode pvst global
configuration command.
This example shows how to enter MST configuration mode, map VLANs 10 to 20 to MST instance 1,
name the region region1, set the configuration revision to 1, display the pending configuration, apply the
changes, and return to global configuration mode:
Switch(config)# spanning-tree mst configuration
Switch(config-mst)# instance 1 vlan 10-20
Switch(config-mst)# name region1
Switch(config-mst)# revision 1
Switch(config-mst)# show pending
Pending MST configuration
Name
Revision
Instance
--------
Cisco IE 3000 Switch Software Configuration Guide
17-16
Purpose
Map VLANs to an MST instance.
For instance-id, the range is 0 to 4094.
•
For vlan vlan-range, the range is 1 to 4094.
•
When you map VLANs to an MST instance, the mapping is
incremental, and the VLANs specified in the command are added to
or removed from the VLANs that were previously mapped.
To specify a VLAN range, use a hyphen; for example, instance 1 vlan
1-63 maps VLANs 1 through 63 to MST instance 1.
To specify a VLAN series, use a comma; for example, instance 1 vlan 10,
20, 30 maps VLANs 10, 20, and 30 to MST instance 1.
Specify the configuration name. The name string has a maximum length
of 32 characters and is case sensitive.
Specify the configuration revision number. The range is 0 to 65535.
Verify your configuration by displaying the pending configuration.
Apply all changes, and return to global configuration mode.
Enable MSTP. RSTP is also enabled.
Caution
You cannot run both MSTP and PVST+ or both MSTP and rapid PVST+
at the same time.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
[region1]
1
Vlans Mapped
---------------------
Changing spanning-tree modes can disrupt traffic because all
spanning-tree instances are stopped for the previous mode and
restarted in the new mode.
Chapter 17
Configuring MSTP
OL-13018-01
Advertisement
Chapters
Table of Contents
Troubleshooting
