Port-Channel Interfaces - Cisco IE 3000 Software Configuration Manual
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Chapter 33
Configuring EtherChannels and Link-State Tracking
Port-Channel Interfaces
When you create a Layer 2 EtherChannel, a port-channel logical interface is involved. You can create
the EtherChannel in these ways:
•
•
Each EtherChannel has a port-channel logical interface numbered from 1 to 6. This port-channel
interface number corresponds to the one specified with the channel-group interface configuration
command.
Figure 33-2
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
to all the physical ports assigned to the port-channel interface. Configuration changes applied to the
physical port affect only the port where you apply the configuration. To change the parameters of all
ports in an EtherChannel, apply configuration commands to the port-channel interface, for example,
spanning-tree commands or commands to configure a Layer 2 EtherChannel as a trunk.
OL-13018-01
Use the channel-group interface configuration command. This command automatically creates the
port-channel logical interface when the channel group gets its first physical port. The
channel-group command binds the physical (10/100/1000 ports) and the logical ports together as
shown in
Figure
33-2.
Use the interface port-channel port-channel-number global configuration command to manually
create the port-channel logical interface. Then use the channel-group channel-group-number
interface configuration command to bind the logical interface to a physical port. The
channel-group-number can be the same as the port-channel-number, or you can use a new number.
If you use a new number, the channel-group command dynamically creates a new port channel.
Relationship of Physical Ports, Logical Port Channels, and Channel Groups
Logical
port-channel
Channel-group
binding
Physical ports
Cisco IE 3000 Switch Software Configuration Guide
Understanding EtherChannels
33-3
Advertisement
Chapters
Table of Contents
Troubleshooting
