Cisco CVR100W Administration Manual page 78
Wireless-n 300m router
Hide thumbs
Also See for CVR100W:
- Administration manual (150 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (9 pages)
Table of Contents
Advertisement
Configuring Firewall
Configuring Access Control
STEP 7
STEP 8
STEP 9
STEP 10
STEP 11
STEP 12
Cisco CVR100W Wireless-N 300M Router Administration Guide
•
Telnet
•
Telnet Secondary
•
Telnet SSL
•
Voice (SIP)
In the Source IP field, select the users to which the access rule applies:
•
Any: The rule applies to traffic originating on any host in the local network.
•
Single Address: The rule applies to traffic originating on a single IP address
in the local network. Enter the address in the Start IP field.
•
Address Range: The rule applies to traffic originating from an IP address
located in a range of addresses. Enter the starting IP address in the Start IP
field, and the ending IP address in the Finish field.
In the Destination IP field, select the users to which the access rule applies:
•
Any: The rule applies to traffic originating on any host in the local network.
•
Single Address: The rule applies to traffic originating on a single IP address
in the local network. Enter the address in the Start IP field.
•
Address Range: The rule applies to traffic originating from an IP address
located in a range of addresses. Enter the starting IP address in the Start IP
field, and the ending IP address in the Finish field.
In the Log field, specify whether the packets for this rule should be logged.
To log details for all packets that match this rule, choose Always from the drop-
down menu. For example, if an outbound rule for a schedule is selected as Always
block, for every packet that tries to make an outbound connection for that service,
a message with the packet's source address and destination address (and other
information) is recorded in the log.
Enabling logging may generate a significant volume of log messages and is
recommended for debugging purposes only.
Choose Never to disable logging.
In the QoS Priority field, assign a priority to IP packets of this service.
The priorities are defined by QoS Level: (1 (lowest), 2, 3, 4 (highest)).
In the Rule Status field, check to enable the new access rule.
Click Save.
4
76
Advertisement
Table of Contents
