Configuring Wds - Cisco CVR100W Administration Manual
Wireless-n 300m router
Hide thumbs
Also See for CVR100W:
- Administration manual (150 pages) ,
- Quick start manual (9 pages) ,
- Quick start manual (9 pages)
Table of Contents
Advertisement
Configuring Wireless Network
Configuring WDS
Configuring WDS
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
Cisco CVR100W Wireless-N 300M Router Administration Guide
A Wireless Distribution System (WDS) is a system that enables the wireless
interconnection of access points in a network. It allows a wireless network to be
expanded using multiple access points without the need for a wired backbone to
link them.
To establish a WDS link, the CVR100W and other remote WDS peers must be
configured in the same wireless network mode, wireless channel, wireless band
selection, and encryption types (None and WEP).
WDS is supported on SSID 1 only.
To configure a WDS:
Choose Wireless > WDS.
Check Allow wireless signal to be repeated by a repeater to enable WDS.
To manually enter the MAC address of a repeater, click the Manual radio button.
(Optional) Click the Show Site Survey button.
The Available Networks Table appears listing the available wireless network
access points.
•
(Optional) Click the Refresh button to update the entries in the table.
•
In the Available Networks Table, select up to three access points to use as
repeaters.
•
To add the MAC addresses of the selected access points to the MAC fields
below the table, click Connect.
If you click the Manual radio button, enter the MAC addresses of up to three
access points to use as repeaters in the MAC 1, MAC 2, MAC 3 fields.
Click Save.
3
65
Advertisement
Table of Contents
