Cisco Catalyst 3560-X Software Configuration Manual page 1007

Hide thumbs Also See for Catalyst 3560-X:

Table of Contents

Configuring IPv6 ACLs

You can filter IP Version 6 (IPv6) traffic by creating IPv6 access control lists (ACLs) and applying them

to interfaces similarly to the way that you create and apply IP Version 4 (IPv4) named ACLs. You can

also create and apply input router ACLs to filter Layer 3 management traffic when the switch is running

the IP base feature set.

IPv6 ACLs are not supported on switches running the LAN base feature set.

This chapter includes information about configuring IPv6 ACLs on the switch. Unless otherwise noted,

the term switch refers to a Catalyst 3750-X or 3560-X standalone switch and to a Catalyst 3750-X switch

To use IPv6, you must configure the dual IPv4 and IPv6 Switch Database Management (SDM) template

on the switch. You select the template by entering the sdm prefer dual-ipv4-and-ipv6 {default |

routing | vlan} global configuration command.

For related information, see these chapters:

For more information about SDM templates, see

For information about IPv6 on the switch,

For information about ACLs on the switch, see

For complete syntax and usage information for the commands used in this chapter, see the command

reference for this release or the Cisco IOS documentation referenced in the procedures.

This chapter contains these sections:

Understanding IPv6 ACLs, page 1-2

Configuring IPv6 ACLs, page 1-4

Displaying IPv6 ACLs, page 1-8

C H A P T E R

Chapter 1, "Configuring SDM Templates."

seeChapter 1, "Configuring IPv6 Unicast

Chapter 1, "Configuring Network Security with

Catalyst 3750-X and 3560-X Switch Software Configuration Guide

Troubleshooting

Catalyst 3750-x