Displaying Ipv4 Acl Configuration - Cisco Catalyst 3560-X Software Configuration Manual

Hide thumbs Also See for Catalyst 3560-X:

Table of Contents

Displaying IPv4 ACL Configuration

Displaying IPv4 ACL Configuration

You can display the ACLs that are configured on the switch, and you can display the ACLs that have

been applied to interfaces and VLANs.

When you use the ip access-group interface configuration command to apply ACLs to a Layer 2 or 3

interface, you can display the access groups on the interface. You can also display the MAC ACLs

applied to a Layer 2 interface. You can use the privileged EXEC commands as described in

display this information.

Commands for Displaying Access Lists and Access Groups

show access-lists [number | name]

show ip access-lists [number | name]

show ip interface interface-id

show running-config [interface interface-id]

show mac access-group [interface interface-id]

Catalyst 3750-X and 3560-X Switch Software Configuration Guide

Applying ACLs on Multicast Packets

Display the contents of one or all current IP and MAC address access lists

or a specific access list (numbered or named).

Display the contents of all current IP access lists or a specific IP access list

(numbered or named).

Display detailed configuration and status of an interface. If IP is enabled

on the interface and ACLs have been applied by using the ip access-group

interface configuration command, the access groups are included in the

Displays the contents of the configuration file for the switch or the

specified interface, including all configured MAC and IP access lists and

which access groups are applied to an interface.

Displays MAC access lists applied to all Layer 2 interfaces or the specified

Layer 2 interface.

Routing function

Configuring Network Security with ACLs

Catalyst 3750-x