Cisco Catalyst 3560-X Software Configuration Manual page 806
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Configuring SPAN and RSPAN
•
•
•
•
•
•
•
•
Configuring a VLAN as an RSPAN VLAN
First create a new VLAN to be the RSPAN VLAN for the RSPAN session. You must create the RSPAN
VLAN in all switches that will participate in RSPAN. If the RSPAN VLAN-ID is in the normal range
(lower than 1005) and VTP is enabled in the network, you can create the RSPAN VLAN in one switch,
and VTP propagates it to the other switches in the VTP domain. For extended-range VLANs (greater
than 1005), you must configure RSPAN VLAN on both source and destination switches and any
intermediate switches.
Use VTP pruning to get an efficient flow of RSPAN traffic, or manually delete the RSPAN VLAN from
all trunks that do not need to carry the RSPAN traffic.
Beginning in privileged EXEC mode, follow these steps to create an RSPAN VLAN:
Command
Step 1
configure terminal
Step 2
vlan vlan-id
Step 3
remote-span
Step 4
end
Step 5
copy running-config startup-config
To remove the remote SPAN characteristic from a VLAN and convert it back to a normal VLAN, use the
no remote-span VLAN configuration command.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-18
For RSPAN configuration, you can distribute the source ports and the destination ports across
multiple switches in your network.
RSPAN does not support BPDU packet monitoring or other Layer 2 switch protocols.
The RSPAN VLAN is configured only on trunk ports and not on access ports. To avoid unwanted
traffic in RSPAN VLANs, make sure that the VLAN remote-span feature is supported in all the
participating switches.
Access ports (including voice VLAN ports) on the RSPAN VLAN are put in the inactive state.
RSPAN VLANs are included as sources for port-based RSPAN sessions when source trunk ports
have active RSPAN VLANs. RSPAN VLANs can also be sources in SPAN sessions. However, since
the switch does not monitor spanned traffic, it does not support egress spanning of packets on any
RSPAN VLAN identified as the destination of an RSPAN source session on the switch.
You can configure any VLAN as an RSPAN VLAN as long as these conditions are met:
The same RSPAN VLAN is used for an RSPAN session in all the switches.
–
All participating switches support RSPAN.
–
We recommend that you configure an RSPAN VLAN before you configure an RSPAN source or a
destination session.
If you enable VTP and VTP pruning, RSPAN traffic is pruned in the trunks to prevent the unwanted
flooding of RSPAN traffic across the network for VLAN IDs that are lower than 1005.
Purpose
Enter global configuration mode.
Enter a VLAN ID to create a VLAN, or enter the VLAN ID of an
existing VLAN, and enter VLAN configuration mode. The range is
2 to 1001 and 1006 to 4094.
The RSPAN VLAN cannot be VLAN 1 (the default VLAN) or VLAN
IDs 1002 through 1005 (reserved for Token Ring and FDDI VLANs).
Configure the VLAN as an RSPAN VLAN.
Return to privileged EXEC mode.
(Optional) Save the configuration in the configuration file.
Chapter 1
Configuring SPAN and RSPAN
OL-25303-03
Advertisement
Table of Contents
Troubleshooting
