Registering And Defining An Embedded Event Manager Applet - Cisco Catalyst 3560-X Software Configuration Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Command reference manual (1188 pages) ,
- Software configuration manual (1438 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Configuring Embedded Event Manager
•
Note
EEM 3.2 also introduces CLI commands to support the applets to work with the new event detectors.
For further details about EEM 3.2 features, see the Embedded Event Manager 3.2 document:
http://www.cisco.com/en/US/docs/ios/netmgmt/configuration/guide/nm_eem_3.2.html
Configuring Embedded Event Manager
•
•
For complete information about configuring embedded event manager, see the Cisco IOS Network
Management Configuration Guide, Release 12.4T.
To configure EEM, you must have the IP services feature set installed on the switch.
Note
Registering and Defining an Embedded Event Manager Applet
Beginning in privileged EXEC mode, perform this task to register an applet with EEM and to define the
EEM applet using the event applet and action applet configuration commands.
Only one event applet command is allowed in an EEM applet. Multiple action applet commands are
Note
permitted. If you do not specify the no event and no action commands, the applet is removed when you
exit configuration mode.
Command
Step 1
configure terminal
Step 2
event manager applet applet-name
Step 3
event snmp oid oid-value get-type
{exact | next} entry-op {eq | ge | gt | le |
lt | ne} entry-val entry-val [exit-comb
{or | and}] [exit-op {eq | ge | gt | le | lt |
ne}] [exit-val exit-val] [exit-time
exit-time-val] poll-interval poll-int-val
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-6
Mac-Address-Table—Mac-Address-Table event detector generates an event when a MAC address is
learned in the MAC address table.
The Mac-Address-Table event detector is supported only on switch platforms and can be used
only on Layer 2 interfaces where MAC addresses are learned. Layer 3 interfaces do not learn
addresses,and routers do not usually support the MAC address-table infrastructure needed to
notify EEM of a learned MAC address.
Registering and Defining an Embedded Event Manager Applet, page 1-6
Registering and Defining an Embedded Event Manager TCL Script, page 1-7
Purpose
Enter global configuration mode.
Register the applet with EEM and enter applet configuration mode.
Specify the event criteria that causes the EEM applet to run.
(Optional) Exit criteria. If exit criteria are not specified, event monitoring
is re-enabled immediately.
Chapter 1
Configuring Embedded Event Manager
OL-25303-03
Advertisement
Table of Contents
Troubleshooting
