Chapter 12 Configuring Smartports Macros; Understanding Smartports Macros - Cisco IE 3000 Software Configuration Manual
Hide thumbs
Also See for IE 3000:
- Hardware installation manual (186 pages) ,
- Getting started manual (32 pages) ,
- Software configuration manual (874 pages)
Table of Contents
Advertisement
Configuring Smartports Macros
This chapter describes how to configure and apply Smartports macros on the IE 3000 switch.
For complete syntax and usage information for the commands used in this chapter, see the command
Note
reference for this release.
This chapter consists of these sections:
•
•
•
Understanding Smartports Macros
Smartports macros provide a convenient way to save and share common configurations. You can use
Smartports macros to enable features and settings based on the location of a switch in the network and
for mass configuration deployments across the network.
Each Smartports macro is a set of command-line interface (CLI) commands that you define. Smartports
macros do not contain new CLI commands; they are simply a group of existing CLI commands.
When you apply a Smartports macro to an interface, the CLI commands within the macro are configured
on the interface. When the macro is applied to an interface, the existing interface configurations are not
lost. The new commands are added to the interface and are saved in the running configuration file.
There are global configuration and interface configuration Cisco-default Smartports macros embedded
in the switch software (see
commands they contain by using the show parser macro user EXEC command.
Table 12-1
Cisco-Default Smartports Macros
1
Macro Name
Description
cisco-global
Use this global configuration macro to enable rapid PVST+, loop guard, and dynamic port error recovery
for link state failures.
2
cisco-ie-global
Use this global configuration macro to configure the switch settings for the industrial Ethernet
environment. This macro is automatically applied when you use Express Setup to initially configure the
switch.
OL-13018-01
Understanding Smartports Macros, page 12-1
Configuring Smartports Macros, page 12-2
Displaying Smartports Macros, page 12-8
Table
C H A P T E R
12-1). You cannot modify these macros. You can display them and the
Cisco IE 3000 Switch Software Configuration Guide
12
12-1
Advertisement
Chapters
Table of Contents
Troubleshooting
