Configuring Alarm Profiles - Cisco IE 3000 Software Configuration Manual

Hide thumbs Also See for IE 3000:

Table of Contents

Configuring Cisco IE 3000 Switch Alarms

This example shows how to set the FCS bit error rate for a port to 10

Switch# configure terminal

Switch(config)# interface fastethernet1/1

Switch(config-if) # fcs-threshold 10

Setting the FCS Error Hysteresis Threshold

The hysteresis setting prevents the toggle of an alarm when the actual bit error-rate fluctuates near the

configured rate. Use the alarm facility fcs-hysteresis global configuration command to set the FCS

error hysteresis threshold.

The FCS hysteresis threshold is applied to all ports of an IE 3000 switch.

Beginning in privileged EXEC mode, follow these steps to set the FCS error hysteresis threshold for a

configure terminal

alarm facility fcs-hysteresis

show running config

copy running-config startup-config (Optional) Save your entries in the configuration file.

Use the no alarm facility fcs-hysteresis command to set the FCS error hysteresis threshold to its default

The show running config command displays any FCS error hysteresis that is not the default value.

This example shows how to set the FCS error hysteresis at 5 percent.

Switch(config)# alarm facility fcs-hysteresis 5

Configuring Alarm Profiles

This section describes how to configure alarm profiles on your switch. It contains this configuration

information:

Enter global configuration mode.

Set the hysteresis percentage for the switch.

For percentage, the range is 1 to 10. The default value is 10 percent.

Return to privileged EXEC mode.

Verify the configuration.

Creating or Modifying an Alarm Profile, page 3-10

Attaching an Alarm Profile to a Specific Port, page 3-11

Configuring IE 3000 Switch Alarms

Cisco IE 3000 Switch Software Configuration Guide

Table of Contents