Siemens SIMATIC S7 System Manual page 423

Hide thumbs Also See for SIMATIC S7:

Table of Contents

CONF_DATA Data block

The following diagram shows how the configuration data to be transferred is stored in the

configuration DB.

S7-1200 Programmable controller

System Manual, 11/2011, A5E02486680-05

The parameters of the CONF_DATA data block field_type_id are invalid or have been

used several times.

LEN length of the IP configuration parameters or subfield_cnt errors

The IP configuration ID parameter is invalid or unsupported.

The Sub-block of the IP configuration is incorrectly placed (Sub-block wrong, wrong order,

or used multiple times).

The length of a statement LEN Sub-blocks is invalid.

The value of the parameter in Sub-blocks mode is invalid.

Sub-block conflict between the IP configuration and a previous Sub-block.

The parameters of the subfield are write-protected (for example: parameters are specified

by configuration, or PNIO mode is enabled).

A parameter in the Sub-block IP configuration has not been defined or may not be used.

There is an inconsistency between a parameter of the Sub-block IP configuration and

other parameters.

Instruction cannot be executed. This error can occur if, for example, communication with

the interface has been lost.

There are not enough resources. This error can occur if, for example, the instruction is

called multiple times with different parameters

Communication failure. The error can occur temporarily and will require a repeat of the

user program.

Execution of the instruction is not supported by the PROFINET interface.

Configuration DB

Configuration data

Subfield-specific parameters

103BCommunication

10.2 PROFINET

Show Quick Links

Table of Contents

Simatic s7-1200