Configuring The Communication Module - Siemens SIMATIC S7 System Manual

Hide thumbs Also See for SIMATIC S7:

Table of Contents

You must connect the communication interface of the CM 1241 RS232 module to the RS232

interface of the PC, which is normally COM1. Because both of these ports are Data Terminal

Equipment (DTE), you must switch the receive and transmit pins (2 and 3) when connecting

the two ports, which you can accomplish by either of the following methods:

● Use a NULL modem adapter to swap pins 2 and 3 together with a standard RS232 cable.

● Use a NULL modem cable, which already has pins 2 and 3 swapped. You can usually

Configuring the communication module

You can configure the CM 1241 from the Device configuration in STEP 7 or with user

program instructions. This example uses the Device configuration method.

● Port configuration: Click the communication port of the CM module from the Device

● Transmit message configuration: Accept the default for transmit message configuration.

S7-1200 Programmable controller

System Manual, 11/2011, A5E02486680-05

identify a NULL modem cable as one with two female 9-pin D connector ends.

configuration, and configure the port as shown:

The configuration settings for "Operating mode" and "Receive line initial state" are only

applicable for the CM 1241 (RS422/RS485) module. The other CM 1241 modules do not

have these port configuration settings.

No break is to be sent at message start.

105BCommunication processor

12.3 Point-to-Point (PtP) communication

Show Quick Links

Table of Contents

Simatic s7-1200