Source Specific Multicast With Igmpv3, Igmp V3Lite, And Urd; Enabling Ip Multicast Routing Globally; Enabling Ip Pim On Layer 3 Interfaces - Cisco 7609 Configuration Manual
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Configuring IP Multicast Layer 3 Switching
Source Specific Multicast with IGMPv3, IGMP v3lite, and URD
For complete information and procedures about source specific multicast with IGMPv3, IGMP v3lite,
and URL Rendezvous Directory (URD), refer to this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t5/dtssm5t.htm
Enabling IP Multicast Routing Globally
You must enable IP multicast routing globally before you can enable IP multicast Layer 3 switching on
Layer 3 interfaces.
For complete information and procedures, refer to these publications:
•
•
To enable IP multicast routing globally, perform this task:
Command
Router(config)# ip multicast-routing
Router(config)# no ip multicast-routing
This example shows how to enable multicast routing globally:
Router(config)# ip multicast-routing
Router(config)#
Enabling IP PIM on Layer 3 Interfaces
You must enable PIM on the Layer 3 interfaces before IP multicast Layer 3 switching functions on those
interfaces.
To enable IP PIM on a Layer 3 interface, perform this task:
Command
Step 1
Router(config)# interface {{vlan vlan_ID} |
1
{type
slot/port}}
Step 2
Router(config-if)# ip pim {dense-mode |
sparse-mode | sparse-dense-mode}
Router(config-if)# no ip pim [dense-mode |
sparse-mode | sparse-dense-mode]
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to enable PIM on an interface using the default mode (sparse-dense-mode):
Router(config-if)# ip pim
Router(config-if)#
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
18-10
Cisco IOS IP and IP Routing Configuration Guide, Release 12.1, at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_c/index.htm
Cisco IOS IP and IP Routing Command Reference, Release 12.1, at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_r/index.htm
Chapter 18
Purpose
Enables IP multicast routing globally.
Disables IP multicast routing globally.
Purpose
Selects an interface to configure.
Enables IP PIM on a Layer 3 interface.
Disables IP PIM on a Layer 3 interface.
Configuring IP Multicast Layer 3 Switching
78-14064-04
Advertisement
Table of Contents
Troubleshooting
