Cisco 7609 Configuration Manual page 436
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Configuring PFC QoS
These commands configure traffic classes and the policies to be applied to those traffic classes and attach
the policies to ports:
•
access-list (Optional for IP traffic. You can filter IP traffic with class-map commands.):
Protocol
IP
1
IPX
MAC Layer
1. Supported with Release 12.1(1)E and later.
2. Supported with Release 12.1(1)E and later; see the
section on page
class-map (optional)—Enter the class-map command to define one or more traffic classes by
•
specifying the criteria by which traffic is classified (see the
section on page
Note
•
policy-map—Enter the policy-map command to define the following:
•
service-policy—Enter the service-policy command to attach a policy map to an interface.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
32-38
–
PFC QoS supports these access list types:
Numbered Access Lists?
Yes:
1 to
99
1300 to 1999
Yes: 800 to 899
1
No
32-39.
–
In Release 12.1(19)E and later releases, PFC QoS supports time-based Cisco IOS ACLs.
–
In Release 12.1(1)E and later releases, PFC QoS supports IPX access lists that contain a
source-network parameter and the optional destination-network and destination-node
parameters. PFC QoS does not support IPX access control lists that contain other parameters
(for example, source-node, protocol, source-socket, destination-socket, or service-type).
–
Except for MAC-Layer named access lists (see the
Lists (Optional)" section on page
Release 12.1, "Traffic Filtering and Firewalls," "Access Control Lists: Overview and
Guidelines," at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/secur_c/scprt3/ind
ex.htm
See
Chapter 23, "Configuring Network Security,"
–
Cisco 7600 series routers.
32-40).
You can also create class-maps during policy map creation with the policy-map class
command (see the
"Creating a Policy Map Class and Configuring Filtering" section on
page
32-43).
New class maps
–
Policy map class trust mode
–
Aggregate policing and marking
–
Microflow policing and marking
–
Extended Access Lists?
Yes:
100 to 199
2000 to 2699
Yes: 900 to 999
No
"Configuring MAC-Layer Named Access Lists (Optional)"
"Configuring MAC-Layer Named Access
32-39), refer to the Cisco IOS Security Configuration Guide,
for additional information about ACLs on the
"Configuring a Class Map (Optional)"
Chapter 32
Configuring PFC QoS
Named Access Lists?
Yes
Yes
2
Yes
78-14064-04
Advertisement
Table of Contents
Troubleshooting
