Copying Files To The Redundant Supervisor Engine - Cisco 7609 Configuration Manual

Cisco ios software configuration guide—12.1e

Hide thumbs Also See for 7609:

Table of Contents

Configuring RPR and RPR+ Supervisor Engine Redundancy

Copying Files to the Redundant Supervisor Engine

This example shows how to perform an FSU:

Router# config terminal

Router(config)# config-register 0x2

Router(config)# boot system flash slot0: c6sup22-jsv-mz.121-11.E

Router# copy running-config start-config

Router# hw-module reset

Router# redundancy force-switchover

Copying Files to the Redundant Supervisor Engine

Use the following command to copy a file to the slot0: device on a redundant supervisor engine:

Router# copy source_device:source_filename slaveslot0:target_filename

Use the following command to copy a file to the bootflash: device on a redundant supervisor engine:

Router# copy source_device:source_filename slavesup-bootflash:target_filename

Use the following command to copy a file to the bootflash: device on a redundant MSFC:

Router# copy source_device:source_filename slavebootflash:target_filename

Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E