Displaying Traffic Storm Control Settings - Cisco 7609 Configuration Manual
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Displaying Traffic Storm Control Settings
Displaying Traffic Storm Control Settings
To display traffic storm control information, use the commands described in
Table 28-1 Commands for Displaying Traffic Storm Control Status and Configuration
Command
Router# show interfaces [{type
{port-channel number}] switchport
Router# show interfaces [{type
{port-channel number}] counters broadcast
Router# show interfaces [{type
{port-channel number}] counters multicast
Router# show interfaces [{type
{port-channel number}] counters unicast
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
The show interfaces [{interface_type slot/port} | {port-channel number}] counters command does not
Note
display the discard count. You must use one of the traffic-type keywords: broadcast, multicast, or
unicast, which all display the same discard count.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
28-4
1
slot/port} |
1
slot/port} |
1
slot/port} |
1
slot/port} |
Chapter 28
Purpose
Displays the administrative and operational status of all
Layer 2 LAN ports or the specified Layer 2 LAN port.
There is a single counter for all suppressed traffic. These
commands all display the same discard count, which
shows the total number of packets discarded for all three
traffic storm control modes, on all interfaces or on the
specified interface.
Configuring Traffic Storm Control
Table
28-1.
78-14064-04
Advertisement
Table of Contents
Troubleshooting
