Configuring The Mls Aging Time - Cisco 7609 Configuration Manual
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Chapter 20
Configuring IPX Unicast Layer 3 Switching on Supervisor Engine 1
To display the IPX MLS interface configuration, perform this task:
Command
Router# show [ipx [interface {{vlan vlan_ID} |
1
{type
slot/port} | {port-channel number}}] | nde]
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to display interface IPX MLS information for interface VLAN 200:
Router# show ipx interface vlan 200
Vlan200 is up, line protocol is up
IPX address is 2.0050.3e8d.6400, NOVELL-ETHER [up]
Delay of this IPX network, in ticks is 1 throughput 0 link delay 0
IPXWAN processing not enabled on this interface.
IPX SAP update interval is 60 seconds
IPX type 20 propagation packet forwarding is disabled
Incoming access list is not set
Outgoing access list is not set
IPX helper access list is not set
SAP GGS output filter list is not set
SAP GNS processing enabled, delay 0 ms, output filter list is not set
SAP Input filter list is not set
SAP Output filter list is not set
SAP Router filter list is not set
Input filter list is not set
Output filter list is not set
Router filter list is not set
Netbios Input host access list is not set
Netbios Input bytes access list is not set
Netbios Output host access list is not set
Netbios Output bytes access list is not set
Updates each 60 seconds aging multiples RIP: 3 SAP: 3
SAP interpacket delay is 55 ms, maximum size is 480 bytes
RIP interpacket delay is 55 ms, maximum size is 432 bytes
RIP response delay is not set
IPX accounting is disabled
IPX fast switching is configured (enabled)
RIP packets received 0, RIP packets sent 1, 0 Throttled
RIP specific requests received 0, RIP specific replies sent 0
RIP general requests received 0, 0 ignored, RIP general replies sent 0
SAP packets received 0, SAP packets sent 1, 0 Throttled
SAP GNS packets received 0, SAP GNS replies sent 0
SAP GGS packets received 0, 0 ignored, SAP GGS replies sent 0
IPX mls switching is enabled
Router#
Configuring the MLS Aging Time
The MLS aging time applies to all MLS cache entries. See the
section on page
IPX MLS does not use fast aging.
Note
78-14064-04
33-10.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
Purpose
Displays MLS details for an interface.
"Configuring the MLS Aging Time"
Configuring IPX MLS
20-7
Advertisement
Table of Contents
Troubleshooting
