Stp Protocol Timers; Creating The Spanning Tree Topology - Cisco 7609 Configuration Manual
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Chapter 15
Configuring STP and IEEE 802.1s MST
The STP root bridge is the logical center of the spanning tree topology in a Layer 2 network. All paths
that are not needed to reach the root bridge from anywhere in the Layer 2 network are placed in STP
blocking mode.
BPDUs contain information about the transmitting bridge and its ports, including bridge and MAC
addresses, bridge priority, port priority, and path cost. STP uses this information to elect the root bridge
for the Layer 2 network, to elect the root port leading to the root bridge, and to determine the designated
port for each Layer 2 segment.
STP Protocol Timers
Table 15-3
Table 15-3 STP Protocol Timers
Variable
Hello timer
Forward delay timer
Maximum age timer
Creating the Spanning Tree Topology
In
Figure
devices is set to the default (32768) and Switch A has the lowest MAC address. However, due to traffic
patterns, number of forwarding ports, or link types, Switch A might not be the ideal root bridge. By
increasing the priority (lowering the numerical value) of the ideal network device so that it becomes the
root bridge, you force an STP recalculation to form a new spanning tree topology with the ideal network
device as the root.
Figure 15-1 Spanning Tree Topology
DP
RP = Root Port
DP = Designated Port
When the spanning tree topology is calculated based on default parameters, the path between source and
destination end stations in a switched network might not be ideal. For instance, connecting higher-speed
links to a port that has a higher number than the current root port can cause a root-port change. The goal
is to make the fastest link the root port.
78-14064-04
describes the STP protocol timers that affect STP performance.
Description
Determines how often the network device broadcasts hello messages to other
network devices.
Determines how long each of the listening and learning states last before the
port begins forwarding.
Determines the amount of time protocol information received on an port is
stored by the network device.
15-1, Switch A is elected as the root bridge because the bridge priority of all the network
DP
DP
A
RP
DP
RP
DP
RP
B
C
D
DP
DP
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
Understanding How STP Works
15-5
Advertisement
Table of Contents
Troubleshooting
