Understanding Embedded Ciscoview; Installing And Configuring Embedded Ciscoview - Cisco 7609 Configuration Manual
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Configuring Embedded CiscoView Support
Understanding Embedded CiscoView
The Embedded CiscoView network management system is a web-based interface that uses HTTP and
SNMP to provide a graphical representation of the router and to provide a GUI-based management and
configuration interface. You can download the Java Archive (JAR) files for Embedded CiscoView at
this URL:
http://www.cisco.com/kobayashi/sw-center/netmgmt/ciscoview/embed-cview-planner.shtml
Installing and Configuring Embedded CiscoView
To install and configure Embedded CiscoView, perform the following steps:
Command
Step 1
Router# dir device_name
Step 2
Router# delete device_name:cv/*
Step 3
Router# squeeze device_name:
Step 4
Router# archive tar /xtract tftp://
ip address of tftp server/ciscoview.tar
device_name:cv
Step 5
Router# dir device_name:
Step 6
Router# configure terminal
Step 7
Router(config)# ip http server
Step 8
Router(config)# snmp-server community string ro
Step 9
Router(config)# snmp-server community string rw
The default password for accessing the router web page is the enable-level password of the router.
Note
For more information about web access to the router, refer to "Using the Cisco Web Browser" in the IOS
Configuration Fundamentals Configuration Guide at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/fun_c/fcprt1/fcd105.htm
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
1-2
Purpose
Displays the contents of the device.
If you are installing Embedded CiscoView for the first
time, or if the CiscoView directory is empty, skip to
Step
4.
Removes existing files from the CiscoView directory.
Recovers the space in the file system.
Extracts the CiscoView files from the tar file on the TFTP
server to the CiscoView directory.
Displays the contents of the device.
In a redundant configuration, repeat
Step 5
for the file system on the redundant supervisor
engine.
Enters global configuration mode.
Enables the HTTP web server.
Configures the SNMP password for read-only operation.
Configures the SNMP password for read/write operation.
Chapter 1
Product Overview
Step 1
through
78-14064-04
Advertisement
Table of Contents
Troubleshooting
