C H A P T E R 13 Configuring Etherchannels; Etherchannel Feature Overview; Understanding How Etherchannels Are Configured - Cisco 7609 Configuration Manual
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Understanding How EtherChannels Work
EtherChannel Feature Overview
An EtherChannel bundles individual Ethernet links into a single logical link that provides the aggregate
bandwidth of up to eight physical links.
A Cisco 7600 series router supports a maximum of 64 EtherChannels (256 with Release 12.1(2)E and
earlier). You can form an EtherChannel with up to eight compatibly configured LAN ports on any
module in a Cisco 7600 series router. All LAN ports in each EtherChannel must be the same speed and
must all be configured as either Layer 2 or Layer 3 LAN ports.
The network device to which a Cisco 7600 series router is connected may impose its own limits on the
Note
number of ports in an EtherChannel.
If a segment within an EtherChannel fails, traffic previously carried over the failed link switches to the
remaining segments within the EtherChannel. When a failure occurs, the EtherChannel feature sends a
trap that identifies the router, the EtherChannel, and the failed link. Inbound broadcast and multicast
packets on one segment in an EtherChannel are blocked from returning on any other segment of the
EtherChannel.
Understanding How EtherChannels Are Configured
These sections describe how EtherChannels are configured:
•
•
•
•
EtherChannel Configuration Overview
You can configure EtherChannels manually or you can use the Port Aggregation Control Protocol
(PAgP) or, with Release 12.1(13)E and later, the Link Aggregation Control Protocol (LACP) to form
EtherChannels. The EtherChannel protocols allow ports with similar characteristics to form an
EtherChannel through dynamic negotiation with connected network devices. PAgP is a
Cisco-proprietary protocol and LACP is defined in IEEE 802.3ad.
PAgP and LACP do not interoperate with each other. Ports configured to use PAgP cannot form
EtherChannels with ports configured to use LACP. Ports configured to use LACP cannot form
EtherChannels with ports configured to use PAgP.
Table 13-1
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
13-2
EtherChannel Configuration Overview, page 13-2
Understanding Manual EtherChannel Configuration, page 13-3
Understanding PAgP EtherChannel Configuration, page 13-3
Understanding IEEE 802.3ad LACP EtherChannel Configuration, page 13-3
lists the user-configurable EtherChannel modes.
Chapter 13
Configuring EtherChannels
78-14064-04
Advertisement
Table of Contents
Troubleshooting
