Chapter 6 Configuring Interface - Cisco 7609 Configuration Manual
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Chapter 6
Configuring Interfaces
Router#
Enter the show hardware EXEC command to see a list of the system software and hardware:
Step 4
Router# show hardware
Cisco Internetwork Operating System Software
IOS (tm) c6sup2_rp Software (c6sup2_rp-JSV-M), Version 12.1(5c)EX, EARLY DEPLOY)
Synced to mainline version: 12.1(5c)
TAC:Home:Software:Ios General:CiscoIOSRoadmap:12.1
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Wed 28-Mar-01 17:52 by hqluong
Image text-base: 0x30008980, data-base: 0x315D0000
ROM: System Bootstrap, Version 12.1(3r)E2, RELEASE SOFTWARE (fc1)
BOOTFLASH: c6sup2_rp Software (c6sup2_rp-JSV-M), Version 12.1(5c)EX, EARLY DEPL)
Router uptime is 2 hours, 55 minutes
System returned to ROM by power-on (SP by power-on)
Running default software
cisco Catalyst 6000 (R7000) processor with 114688K/16384K bytes of memory.
Processor board ID SAD04430J9K
R7000 CPU at 300Mhz, Implementation 39, Rev 2.1, 256KB L2, 1024KB L3 Cache
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
1 Virtual Ethernet/IEEE 802.3
48 FastEthernet/IEEE 802.3 interface(s)
2 Gigabit Ethernet/IEEE 802.3 interface(s)
381K bytes of non-volatile configuration memory.
16384K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x2
Router#
Step 5
To begin configuring Fast Ethernet port 5/5, enter the interface keyword, interface type, and slot
number/port number at the privileged EXEC prompt, as shown in the following example:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# interface fastethernet 5/5
Router(config-if)#
Note
After each interface command, enter the interface configuration commands your particular interface
Step 6
requires.
The commands you enter define the protocols and applications that will run on the interface. The
commands are collected and applied to the interface command until you enter another interface
command or press Ctrl-Z to get out of interface configuration mode and return to privileged EXEC
mode.
After you configure an interface, check its status by using the EXEC show commands listed in
Step 7
"Monitoring and Maintaining Interfaces" section on page
78-14064-04
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
You do not need to add a space between the interface type and interface number. For example,
in the preceding line you can specify either fastethernet 5/5 or fastethernet5/5.
interface(s)
End with CNTL/Z.
6-17.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
Using the Interface Command
6-3
Advertisement
Table of Contents
Troubleshooting
