Creating Named Aggregate Policers - Cisco 7609 Configuration Manual
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Chapter 32
Configuring PFC QoS
Creating Named Aggregate Policers
To create a named aggregate policer (see the
Command
Router(config)# mls qos aggregate-policer
policer_name bits_per_second normal_burst_bytes
[maximum_burst_bytes] [pir
[[[conform-action {drop | set-dscp-transmit
dscp_value | set-prec-transmit
transmit}] exceed-action {drop | policed-dscp |
transmit}] violate-action
transmit}]
Router(config)# no mls qos aggregate-policer
policer_name
1. Supported only with PFC2.
2. With PFC2, the set-dscp-transmit and set-prec-transmit keywords are only supported for IP traffic.
Note
With PFC2, aggregate policers can be applied to ingress interfaces on multiple modules, but aggregate
policing works independently on each DFC-equipped switching module and independently on the PFC2,
which supports any non-DFC-equipped switching modules. Aggregate policing does not combine flow
statistics from different DFC-equipped switching modules. You can display aggregate policing statistics
for each DFC-equipped switching module and for the PFC2 and any non-DFC-equipped switching
modules supported by the PFC2.
When creating a named aggregate policer, note the following:
•
•
•
•
•
•
78-14064-04
1
peak_rate_bps]
2
2
ip_precedence_value |
1
{drop | policed-dscp |
Policing uses the Layer 3 packet size.
See the
"PFC QoS Configuration Guidelines and Restrictions" section on page 32-31
information about rate and burst size granularity.
The valid range of values for the CIR bits_per_second parameter is as follows:
–
Minimum—32 kilobits per second, entered as 32000
–
Maximum—4 gigabits per second, entered as 4000000000
The normal_burst_bytes parameter sets the CIR token bucket size.
The maximum_burst_bytes parameter sets the PIR token bucket size.
When configuring the size of a token bucket, note the following:
The minimum token bucket size is 1 kilobyte, entered as 1000 (the maximum_burst_bytes
–
parameter must be set larger than the normal_burst_bytes parameter)
The maximum token bucket size is approximately 32 megabytes, entered as 31250000
–
To sustain a specific rate, set the token bucket size to be at least the rate value divided by 4000,
–
because tokens are removed from the bucket every 1/4000th of a second (0.25 ms).
Because the token bucket must be large enough to hold at least one frame, set the parameter
–
larger than the maximum Layer 3 packet size of the traffic being policed.
For TCP traffic, configure the token bucket size as a multiple of the TCP window size, with a
–
minimum value at least twice as large as the maximum Layer 3 packet size of the traffic being
policed.
"Policers" section on page
Purpose
Creates a named aggregate policer.
Deletes a named aggregate policer.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
Configuring PFC QoS
32-19), perform this task:
for
32-35
Advertisement
Table of Contents
Troubleshooting
