Cisco 7609 Configuration Manual page 91
Cisco ios software configuration guide—12.1e
Hide thumbs
Also See for 7609:
- Installing (22 pages) ,
- Datasheet (5 pages) ,
- Frequently asked questions (5 pages)
Table of Contents
Advertisement
Chapter 6
Configuring Interfaces
Table 6-1
Link Negotiation State
Local Port
Off
On
Off
On
To configure link negotiation on a port, perform this task:
Command
Step 1
Router(config)# interface gigabitethernet
slot/port
Step 2
Router(config-if)# speed nonegotiate
Router(config-if)# no speed nonegotiate
This example shows how to enable link negotiation on Gigabit Ethernet port 5/4:
Router(config)# interface gigabitethernet 5/4
Router(config-if)# no speed nonegotiate
Displaying the Speed and Duplex Mode Configuration
To display the speed and duplex mode configuration for a port, perform this task:
Command
Router# show interfaces type
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to display the speed and duplex mode of Fast Ethernet port 5/4:
Router# show interfaces fastethernet 5/4
FastEthernet5/4 is up, line protocol is up
Hardware is Cat6K 100Mb Ethernet, address is 0050.f0ac.3058 (bia 0050.f0ac.3058)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:33, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
78-14064-04
Link Negotiation Configuration and Possible Link Status
Remote Port
Off
On
On
Off
1
slot/port
reliability 255/255, txload 1/255, rxload 1/255
1238 packets input, 273598 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
Link Status
Local Port
Up
Up
Up
Down
Purpose
Selects the port to be configured.
Disables link negotiation.
Reverts to the default configuration (link negotiation
enabled).
Purpose
Displays the speed and duplex mode configuration.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E
Configuring Optional Interface Features
Remote Port
Up
Up
Down
Up
6-9
Advertisement
Table of Contents
Troubleshooting
