Usage Guidelines For Match Commands - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Traffic Classification Using Class Maps
Cisco IOS Release
Release 12.2(31)SB2
Release 12.2(33)SB
Usage Guidelines for match Commands
match ip dscp
•
match ip precedence
•
match ip rtp
•
•
match mpls-experimental-topmost
•
•
•
match not
•
Cisco 10000 Series Router Quality of Service Configuration Guide
2-10
Command
match cos
match ip dscp
match vlan
match fr-de
You must use the ip keyword to match DSCP values for IPv4 packets. The router supports only
DSCP matching of IPv4 packets.
You must use the ip keyword to match precedence values for IPv4 packets. The router supports only
precedence matching of IPv4 packets.
Use this command to match IP RTP packets destined to all even-numbered user datagram port (UDP)
port numbers in the range you specify.
Matching on the RTP port range is particularly effective for applications that use RTP, such as voice
or video.
Use this command to include matching on the EXP bit value on the topmost label entry of the packet.
You can enter this command on input and output interfaces.
This command matches only on MPLS packets.
Use this command to specify a QoS policy value that is not used as a match criterion. When you use
the match not command, all other values of that QoS policy become successful match criteria.
For example, if you enter the match not qos-group 4 command in class-map configuration mode,
the specified class accepts all QoS group values except 4 as successful match criteria.
Chapter 2
Description
This command was introduced on the
PRE3 to include matching on the class of
service for inbound policies only.
This command was introduced on the
PRE3 to include matching on the IP DSCP
value on the L2TP access concentrator
(LAC).
This command was introduced on the
PRE3 to include matching on the VLAN
ID for VLAN-group traffic classes.
This command was introduced on the
PRE2, PRE3, and PRE4 to include
matching on the Frame Relay discard
eligibility (DE) bit.
Classifying Traffic
OL-7433-09
Advertisement
Chapters
Table of Contents
