Applying Qos Parameters Dynamically To Sessions; Applying Traffic Shaping Parameters Using Radius Profiles; Dbs Enable Command; Default Dbs Enable Command - Cisco 10000 Series Configuration Manual

Quality of service configuration guide

Hide thumbs Also See for 10000 Series:

Table of Contents

QoS Features, Commands, and Changes

Applying QoS Parameters Dynamically to Sessions

Documentation Reference:

Cisco IOS Release: Release 12.3(7)XI2

Description: The Define Interface Policy-Map AV Pairs AAA feature was introduced on the PRE2 to

provide two RADIUS vendor-specific attributes (VSAs): cisco-avpair = "atm:vc-qos-policy-in=<in

policy name>" and cisco-avpair = "atm:vc-qos-policy-out=<out policy name>". These VSAs allow you

to apply (pull) a policy map on an ATM virtual circuit (VC) during Point-to-Point Protocol over ATM

(PPPoA) or PPP over Ethernet over ATM (PPPoEoA) session establishment.

Cisco IOS Release: Release 12.2(28)SB

Description: This feature was integrated in Cisco IOS Release 12.2(28)SB and enhanced to provide

"push" functionality.

Documentation Reference:

Cisco IOS Release: Release 12.2(16)BX

Description: The dbs enable command was introduced on the PRE2 to enable dynamic bandwidth

Cisco IOS Release: Release 12.2(28)SB

Description: This command was integrated in Cisco IOS Release 12.2(28)SB.

Cisco IOS Release: Release 12.2(16)BX

Description: The default dbs enable command was introduced on the PRE2 to remove the dbs enable

or no dbs enable command from an existing configuration.

Cisco IOS Release: Release 12.2(28)SB

Description: This command was integrated in Cisco IOS Release 12.2(28)SB.

Cisco 10000 Series Router Quality of Service Configuration Guide

VLAN Tag-Based Quality of Service, page 1-60

Chapter 18, "Regulating and Shaping Subscriber Traffic"

Chapter 17, "Configuring Dynamic Subscriber Services"

dbs enable Command, page 1-12

default dbs enable Command, page 1-12

Dynamic Bandwidth Selection Feature, page 1-13

Quality of Service Overview

Table of Contents