Restrictions And Limitations For Frame Relay Pvc Selection; Configuring Frame Relay Bundles - Cisco 10000 Series Configuration Manual

Quality of service configuration guide

Hide thumbs Also See for 10000 Series:

Table of Contents

Configuring Quality of Service for PVC Bundles

Restrictions and Limitations for Frame Relay PVC Selection

VC Selection

Packet Forwarding

To configure Frame Relay bundles, perform the following configuration tasks:

In Cisco IOS Release 12.0(26)S, the Frame Relay implementation of VC bundles is restricted to

You can configure a maximum of eight PVCs in a PVC bundle.

A PVC can be a member of one and only one PVC bundle.

A PVC that is a bundle member cannot be used in any other capacity. For example, you cannot

configure a PVC bundle member in a map statement.

The Cisco 10000 router does not support variable bit rate-real-time (VBR-rt) for PVCs.

A PVC bundle does not come up until you configure all of the precedence or DSCP levels in the

You can map one or multiple precedence or DSCP levels to a single PVC; however, you cannot map

multiple PVCs to one precedence or DSCP level.

The Cisco 10000 router does not support the auto-mapping of PVCs.

The Cisco 10000 router does not support fast switching of IP packets.

Creating a Frame Relay PVC Bundle, page 19-42

Adding a PVC to a Frame Relay PVC Bundle, page 19-43

Cisco 10000 Series Router Quality of Service Configuration Guide

Frame Relay PVC Selection

Table of Contents