Configuration Examples For Dynamic Qos Policies At The Session Level; Configuration Examples For Existing Service Policies And Pulled Policies - Cisco 10000 Series Configuration Manual

Quality of service configuration guide

Hide thumbs Also See for 10000 Series:

Table of Contents

Applying QoS Parameters Dynamically to Sessions

Configuration Examples for Dynamic QoS Policies at the Session Level

This section provides the following configuration examples:

Example 17-16

sample output from the show policy-map command shows that the voice and outname policies are

attached to PVC 4/103 on ATM subinterface 4/0/0.3. The show policy-map interface command displays

statistical information about the policy maps.

Example 17-16 Displaying Existing Service Policies o the Router

Router# show policy-map

interface ATM4/0/0.3 multipoint

no atm enable-ilmi-trap

service-policy input voice

service-policy output outname

Router# show policy-map interface atm 4/0/0.3

ATM4/0/0.3: PVC 4/103 -

Service-policy input: voice

Service-policy output: outname

Cisco 10000 Series Router Quality of Service Configuration Guide

Configuration Examples for Existing Service Policies and Pulled Policies, page 17-30

Configuration Examples for Pulled Policies and a Router Without Existing Policies, page 17-32

the policy maps named voice and outname are already configured on the router. The

Class-map: class-default (match-any)

0 packets, 0 bytes

5 minute offered rate 0 bps, drop rate 0 bps

0 packets, 0 bytes

5 minute rate 0 bps

Class-map: class-default (match-any)

0 packets, 0 bytes

5 minute offered rate 0 bps, drop rate 0 bps

0 packets, 0 bytes

5 minute rate 0 bps

Configuring Dynamic Subscriber Services

Table of Contents