Policy Map Actions—Cisco Ios Release 12.0(22)S And Later Releases; Policy Map Actions—Cisco Ios Release 12.2(31)Sb2 And Later Releases; Policing Actions - Cisco 10000 Series Configuration Manual

Quality of service configuration guide

Hide thumbs Also See for 10000 Series:

Table of Contents

Configuring QoS Policy Actions and Rules

Policy Map Actions—Cisco IOS Release 12.0(22)S and Later Releases

Cisco IOS Release 12.0(22)S adds support for the QoS action command listed in

command is also available in later releases.

set mpls experimental value

Policy Map Actions—Cisco IOS Release 12.2(31)SB2 and Later Releases

Cisco IOS Release 12.2(31)SB2 adds support for the QoS action command listed in

command is also available in later 12.2 SB releases for the PRE3 and PRE4.

priority level level

The police command allows you to specify what you want the router to do when traffic meets, exceeds,

or violates the policing parameters you specified.

supports and the minimum Cisco IOS release required.

Policy Map Actions—Cisco IOS Release 12.0(22)S and Later Releases

Policy Map Actions—Cisco IOS Release 12.2(31)SB2 and Later Releases

Cisco 10000 Series Router Quality of Service Configuration Guide

Copies the setting of the IP precedence or DSCP

bits to the MPLS experimental bits of a packet.

value is a number from 0 to 7. Multiple values must

be space-delimited (for example, 3 4 7).

Assigns priority to a traffic class at the priority

level specified.

level is the level of priority assigned to the priority

class. Valid values are:

1—high priority

2—low priority

The default value for priority is 1.

In the same policy map, do not specify the

same priority level for two different

describes the policing actions the router

Policing Actions

Chapters

Table of Contents