Cisco Ios Configuration Fundamentals Configuration Command Reference, Release 12.2, At; This Url; Http://Www.cisco.com/En/Us/Docs/Ios/Fundamentals/Command/Reference/Cf_Book.html; Configuring The Router - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Chapter 3
Configuring the Router for the First Time
Note
Enter the virtual terminal password when the following is displayed (remember this password for future
Step 6
reference):
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: bambam
In most cases you will use IP routing. If so, you must also select an interior routing protocol, for
Step 7
example, the Enhanced Interior Gateway Routing Protocol (EIGRP).
Enter yes (the default) or press Return to configure IP, and then select EIGRP:
Configure IP? [yes]:
Configure EIGRP routing? [yes]:
Your IGRP autonomous system number [1]: 301
Enter yes or no to accept or refuse SNMP management:
Step 8
Configure SNMP Network Management? [yes]:
Community string [public]:
For complete SNMP information and procedures, refer to these publications:
Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.2, "Cisco IOS System
•
Management," "Configuring SNMP Support," at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/configfun/configuration/guide/fcf014.html
Cisco IOS Configuration Fundamentals Configuration Command Reference, Release 12.2, at
•
this URL:
http://www.cisco.com/en/US/docs/ios/fundamentals/command/reference/cf_book.html
To provide a review of what you have done, a display similar to the following appears and lists all of the
configuration parameters you selected in Steps
shown in the order in which they appeared on your console terminal:
The following configuration command script was created:
hostname router
enable secret 5 $1$S3Lx$uiTYg2UrFK1U0dgWdjvxw.
enable password lab
line vty 0 4
password lab
no snmp-server
!
ip routing eigrp 301
!
interface Vlan1
shutdown
no ip address
!
interface GigabitEthernet1/1
OL-4266-08
An enable secret password can contain from 1 to 25 uppercase and lowercase alphanumeric
characters; an enable password can contain any number of uppercase and lowercase
alphanumeric characters. In both cases, a number cannot be the first character. Spaces are also
valid password characters; for example, "two words" is a valid password. Leading spaces are
ignored; trailing spaces are recognized.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
3
through 8. These parameters and their defaults are
Configuring the Router
3-7
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
