Configuring Exp Value Maps - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Chapter 42
Configuring PFC3BXL or PFC3B Mode MPLS QoS
Configuring EXP Value Maps
These sections describe how EXP values are mapped to other values:
•
•
Configuring an Ingress-EXP to Internal-DSCP Map
To configure an ingress-EXP to internal-DSCP map, perform this task:
Command
Step 1
Router(config)# mls qos map exp-dscp values
Router(config)# no mls qos map exp-dscp
Step 2
Router(config)# end
Step 3
Router# show mls qos maps
This example shows how to configure an ingress-EXP to internal-DSCP map:
Router(config)# mls qos map exp-dscp 43 43 43 43 43 43 43 43
Router(config)#
This example shows how to verify the configuration:
Router(config)# show mls qos map exp-dscp
Exp-dscp map:
Configuring a Named Egress-DSCP to Egress-EXP Map
To configure a named egress-DSCP to egress-EXP map, perform this task:
Command
Step 1
Router(config)# mls qos map dscp-exp dscp_values
to exp_values
Router(config)# no mls qos map dscp-exp
Step 2
Router(config)# end
Step 3
Router# show mls qos maps
This example shows how to configure a named egress-DSCP to egress-EXP map:
Router(config)# mls qos map dscp-exp 20 25 to 3
Router(config)#
OL-4266-08
Configuring an Ingress-EXP to Internal-DSCP Map, page 42-31
Configuring a Named Egress-DSCP to Egress-EXP Map, page 42-31
exp:
0
1
2
3
------------------------------------
dscp:
43 43 43 43 43 43 43 43
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Purpose
Configures the ingress-EXP value to internal-DSCP map.
You must enter eight DSCP values corresponding to the
EXP values. Valid values are 0 through 63.
Reverts to the default map.
Exits configuration mode.
Verifies the configuration.
4
5
6
7
Purpose
Configures a named egress-DSCP to egress-EXP map.
You can enter up to eight DSCP values at one time to a
single EXP value. Valid values are 0 through 7.
Reverts to the default map.
Exits configuration mode.
Verifies the configuration.
Configuring PFC3BXL or PFC3B Mode MPLS QoS
42-31
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
