Setting The Router-To-Client Retransmission Time For Eap-Request Frames - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Chapter 46
Configuring IEEE 802.1X Port-Based Authentication
To change the amount of time that the router waits for client notification, perform this task:
Command
Step 1
Router(config)# interface type
Step 2
Router(config-if)# dot1x timeout tx-period
seconds
Router(config-if)# dot1x timeout tx-period
Step 3
Router(config-if)# end
Step 4
Router# show dot1x all
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to set 60 as the number of seconds that the router waits for a response to an
EAP-request/identity frame from the client before retransmitting the request:
Router(config)# dot1x timeout tx-period 60
Setting the Router-to-Client Retransmission Time for EAP-Request Frames
The client notifies the router that it received the EAP-request frame. If the router does not receive this
notification, the router waits a set period of time, and then retransmits the frame. You may set the amount
of time that the router waits for notification from 1 to 65535 seconds. (The default is 30 seconds.)
To set the router-to-client retransmission time for the EAP-request frames, perform this task:
Command
Step 1
Router(config)# interface type
Step 2
Router(config-if)# dot1x timeout supp-timeout
seconds
Router(config-if)# no dot1x timeout supp-timeout
Step 3
Router# end
Step 4
Router# show dot1x all
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to set the router-to-client retransmission time for the EAP-request frame to
25 seconds:
Router(config-if)# dot1x timeout supp-timeout 25
OL-4266-08
Purpose
1
slot/port
Selects an interface to configure.
Sets the number of seconds that the router waits for a
response to an EAP-request/identity frame from the client
before retransmitting the request.
The range is 1 to 65535 seconds; the default is 30.
Returns to the default retransmission time.
Returns to privileged EXEC mode.
Verifies your entries.
Purpose
1
slot/port
Selects an interface to configure.
Sets the router-to-client retransmission time for the
EAP-request frame.
Returns to the default retransmission time.
Returns to privileged EXEC mode.
Verifies your entries.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Configuring 802.1X Port-Based Authentication
46-13
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
