Configuring Appletalk Routing, Cable Ranges, And Zones - Cisco 7604 Configuration Manual
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Chapter 22
Configuring Layer 3 Interfaces
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet, or ge-wan
This example shows how to enable IPX routing and assign an IPX network address to interface
VLAN 100:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# ipx routing
Router(config)# ipx router rip
Router(config-ipx-router)# network all
Router(config-ipx-router)# interface vlan 100
Router(config-if)# ipx network 100 encapsulation snap
Router(config-if)# no shutdown
Router(config-if)# end
Router# copy running-config startup-config
Configuring AppleTalk Routing, Cable Ranges, and Zones
For complete information and procedures, refer to these publications:
•
•
To configure routing for AppleTalk, perform this task beginning in global configuration mode:
Command
Step 1
Router(config)# appletalk routing
Step 2
Router(config)# interface {vlan vlan_ID } |
1
{ type
slot/port } | {port-channel
port_channel_number }
Step 3
Router(config-if)# appletalk cable-range
cable_range
Step 4
Router(config-if)# appletalk zone zone_name
Step 5
Router(config-if)# no shutdown
Step 6
Router(config-if)# end
Step 7
Router# show interfaces [{vlan vlan_ID } |
1
{ type
slot/port } | {port-channel
port_channel_number }]
Router# show appletalk interfaces [{vlan vlan_ID }
1
| { type
slot/port } | {port-channel
port_channel_number }]
Router# show running-config interfaces [{vlan
vlan_ID } | { type
port_channel_number }]
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet, or ge-wan
This example shows how to enable AppleTalk routing and assign an AppleTalk cable-range and zone
name to interface VLAN 100:
Router# configure terminal
OL-4266-08
Cisco IOS AppleTalk and Novell IPX Configuration Guide, Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/atipx/configuration/guide/fatipx_c.html
Cisco IOS AppleTalk and Novell IPX Command Reference, Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/atipx/command/reference/fatipx_r.html
1
slot/port } | {port-channel
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Configuring AppleTalk Routing, Cable Ranges, and Zones
End with CNTL/Z.
Purpose
Enables AppleTalk routing.
Selects an interface to configure.
Assigns a cable range to the interface.
Assigns a zone name to the interface.
Enables the interface.
Exits configuration mode.
Verifies the configuration.
22-9
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
