Cisco 7604 Configuration Manual page 686
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Configuring PFC QoS
This example shows how to map DSCP 30 to mutated DSCP value 8:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# mls qos map dscp-mutation mutmap1 30 to 8
Router(config)# end
Router#
This example shows how to verify the configuration:
Router# show mls qos map | begin DSCP mutation
DSCP mutation map mutmap1:
<...Output Truncated...>
Router#
In the DSCP mutation map displays, the marked-down DSCP values are shown in the body of the matrix;
Note
the first digit of the original DSCP value is in the column labeled d1 and the second digit is in the top
row. In the example shown, DSCP 30 maps to DSCP 08.
Attaching an Egress DSCP Mutation Map to an Interface
To attach an egress DSCP mutation map to an interface, perform this task:
Command
Step 1
Router(config)# interface {{vlan vlan_ID } |
1
{ type
slot/port [. subinterface ]} |
{port-channel number [. subinterface ]}}
Step 2
Router(config-if)# mls qos dscp-mutation
mutation_map_name
Router(config-if)# no mls qos dscp-mutation
mutation_map_name
Step 3
Router(config-if)# end
Step 4
Router# show running-config interface {{vlan
vlan_ID } | { type
number }}
1.
type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to attach the egress DSCP mutation map named mutmap1 to Fast Ethernet
port 5/36:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# interface fastethernet 5/36
Router(config-if)# mls qos dscp-mutation mutmap1
Router(config-if)# end
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
41-84
d1 :
d2 0
1
2
3
4
-------------------------------------
0 :
00 01 02 03 04 05 06 07 08 09
1 :
10 11 12 13 14 15 16 17 18 19
2 :
20 21 22 23 24 25 26 27 28 29
3 :
08 31 32 33 34 35 36 37 38 39
4 :
40 41 42 43 44 45 46 47 48 49
5 :
50 51 52 53 54 55 56 57 58 59
6 :
60 61 62 63
1
slot/port } | {port-channel
End with CNTL/Z.
(dscp= d1d2)
5
6
7
8
9
Purpose
Selects the interface to configure.
Attaches an egress DSCP mutation map to the interface.
Removes the egress DSCP mutation map from the
interface.
Exits configuration mode.
Verifies the configuration.
End with CNTL/Z.
Chapter 41
Configuring PFC QoS
OL-4266-08
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
